DeXlan IP-KVM Manual do Utilizador descarregar pdf (Página 13)

Single port KVM over IP switch

Step 8 (Option)

Connect the USB jack to the USB socket of the host system while using remote mass storage control.

Step 8

Connect Ethernet and/or modem, depending how you want to access IP-KVM switch

INTERNET

Modem

3.2.1 Connecting Ethernet

The rear side of IP-KVM switch provides a RJ-45 connector for Ethernet. The connector is used either

for a 100 Mbps 100BASE-TX connection or for a 10 Mbps 10BASE-T connection. The adapter can

sense the connection speed and will adjust to the appropriate operation mode automatically.

3.2.1.1 10 Mbps Connection

For 10BASE-T Ethernet networks, the Ethernet adapter uses Category 3, 4, or 5 UTP cable.

To establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.

 Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.

 Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the

adapter’s connector.

3.2.1.2. 100 Mbps Connection

For 100BASE-TX Fast Ethernet networks, IP-KVM switch supports Category 5 UTP cabling.

To establish a 100 Mbps connection, the cable must be connected to a 100BASE-TX hub.

 Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.

 Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the

adapter’s connector.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 77 78

Sem comentários

DeXlan IP-KVM Manual do Utilizador Página 13